cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1314
Views
0
Helpful
5
Replies

ADSL signal is weak

thanaponsom
Level 1
Level 1

Hi

I doubted my internet ADSL is very weak. I used Cisco 877 router to gateway internet.

I faced the problem my cisco 877 can't receive signal from ISP but I replaced to use Linksys Cisco. It worked.

So I remoted to router and issued command show dsl interface atm 0 it can't generate DMT bit per bin it showed error

DMT Bits Per Bin

.Jun  7 10:34:54.487: DSL(ATM0): rcv_cmd_ext_av 0x0 incorrect

.Jun  7 10:34:54.487: DSL(ATM0): Unable to get ADSL_GET_TC_PARAMETERS_AVAILABLE_EXT response for ADSL_GET_TC_PARAMETERS_EXT.

.Jun  7 10:34:55.455: DSL(ATM0): Unexpected ext response 68 received:None

.Jun  7 10:34:55.455: DSL(ATM0): OLR/L2 stats: expect 128 bytes, got 0 bytes

Not able to get complete DMT bin information.Retry "show dsl" after few seconds.

DSL: Training log buffer capability is not enabled

I didn't know what error message is. What does it mean?

However, I showed attenuation, power output and Noise margin

Noise Margin:    14.5 dB                         18.0 dB

Output Power:    19.5 dBm                        11.5 dBm

Attenuation:     35.0 dB                         17.0 dB

5 Replies 5

Hi,

As far as ADSL signa is concerned, your Noise Margin and Attentuation parameter as good; which ( if not fault in IP cloud) should give you stable ADSL service.

show caller

will give you an idea about stability of your ADSL....

HTH,

Smitesh

PS: Please rate if helpful...

Hi Smitesh

I followed your command show caller it showed

                                                                              Active    Idle

  Line           User                                   Service       Time      Time

  Vi2            \  PPPoE         1w3d      00:00:00 

PS.  Do I notice output power parameter?

Seems like your ADSL line is UP and running stable for over 1week...

Can you elaborate what type of problem your are facing...

eg, slow response, frequent disconnection ( which I doubt seeing ADSL parameters and Stability )...

Regards,

Smitesh

I faced disconnection frequently around 2 weeks per 1 time.

1. When it occured, router 877 can't receive siganl from ISP. I try to shut off and shut on it can't receive signal. When I replaced with Linksys Cisco router, it can receive signal. And I placed router 877 again it can receive signal.

2. Sometimes when I restart router, it took a long time to receive PPP signal.

I guess, then issue might be with your modem ( if you are using one )...

And if you are having line coming to your ATM port with RJ11 jack, check the local wiring before calling telco...

Regards,

Smitesh

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card