Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

ADSL to GigEthernet

Hello,

Guys i need someinput. I have got a Cisco 2621-XM router with IOS "flash:c2600-js-mz.123-19.bin". I am trying to have the connection from my ADSL Router to the Gig-E port Connection on the Cisco GSR.

Following is my CE config. Has anyone done any type of testing. Also one thing, i tried and couldn't do is " bundle enable" command. Not even sure if this IOS supports it. i tried to configure it in Gloabl Mode, under ATM0/1 also under PVC0/XX but it didn't take it. Any suggestionsss.....

bridge irb

interface ATM0/1

no ip address

ip mtu 1482

ip pim nbma-mode

ip pim sparse-mode

load-interval 30

no atm ilmi-keepalive

dsl operating-mode auto

bridge-group 1

pvc 0/66

ubr 384

inarp 1

encapsulation aal5snap

max-reserved-bandwidth 100

interface BVI1

mac-address X.X.X

ip address X.X.X.X 255.255.255.252

no ip proxy-arp

bridge 1 protocol ieee

bridge 1 route ip

2 REPLIES
Hall of Fame Super Gold

Re: ADSL to GigEthernet

Hi, first of all, the ip commands that you have under atm0/1 will not have any effect because the interface doesn't have Ip enabled. If you really need these commands, put them under BVI1.

Second, why do you want bundle command?

New Member

Re: ADSL to GigEthernet

Hello,

I agree with you, that ip commands should be used under BVI, because that's what i am using for ADSL configuration, rather then ATM0/1.

I am not sure, someone has recommended to use bundle enable command, i am reading on cisco the implementation of this command.

Thanks,

Hassan...

108
Views
0
Helpful
2
Replies
作成コンテンツを作成するには してください