08-29-2008 04:20 AM - edited 03-03-2019 11:20 PM
show ip int brief
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 x.x.192.253 YES TFTP administratively down down
FastEthernet0/1 unassigned YES TFTP administratively down down
ATM0/0/0 unassigned YES TFTP up up
ATM0/0/0.1 unassigned YES unset administratively down down
Virtual-Access1 unassigned YES unset up up
Virtual-Access2 unassigned YES unset up down
Dialer0 x.x.48.207 YES TFTP up up
Loopback0 x.x.72.88 YES TFTP up up
WES-LOS-2811-2#
interface ATM0/0/0.1 point-to-point
no ip address
shutdown
interface ATM 0/0/0
description *** DSL
no shut
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
no atm ilmi-keepalive
dsl operating-mode auto
pvc 0/38
encapsulation aal5mux ppp dialer
dialer pool-member 1
interface Dialer0
ip address x.x.x.207 255.255.255.224
crypto map SDM_CMAP_1
ip access-group INTERNET-IN in
ip virtual-reassembly
encapsulation ppp
dialer pool 1
dialer-group 1
no cdp enable
ppp authentication chap callin
ppp chap hostname xxxx@xxxx.com
ppp chap password 0 xxxx
dialer-list 1 protocol ip permit
#show int dialer0
Dialer0 is up, line protocol is up (spoofing)
Hardware is Unknown
Internet address is x.x.x.x/27
MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 1 seconds on reset
Interface is bound to Vi2
Last input never, output never, output hang never
Last clearing of "show interface" counters 00:11:31
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/0/16 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 42 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes
0 packets output, 0 bytes
Bound to:
Virtual-Access2 is up, line protocol is down
Hardware is Virtual Access interface
MTU 1500 bytes, BW 640 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP Listen
PPPoATM vaccess, cloned from Dialer0
Vaccess status 0x44
Bound to ATM0/0/0 VCD: 2, VPI: 0, VCI: 38, loopback not set
Keepalive set (10 sec)
DTR is pulsed for 5 seconds on reset
Interface is bound to Di0 (Encapsulation PPP)
Last input never, output never, output hang never
Last clearing of "show interface" counters 00:11:33
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
140 packets output, 1680 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
thanks
Solved! Go to Solution.
09-05-2008 01:28 PM
You may try whether Authentication protocols like (CHAP or PAP) configured properly between the two virtual accesses.
09-05-2008 01:28 PM
You may try whether Authentication protocols like (CHAP or PAP) configured properly between the two virtual accesses.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide