a couple of things: firs of all, you do not use any authentication, is that right ? What is this router connecting to, an ISP ?
Regarding the input errors: try to put the command ´ip mtu 1452´ or ´ip tcp adjust-mss 1452´ on the ATM0.1 subinterface as well. You could also try and change the ´dsl operating-mode´ to ´ansi-dmt´, check if that makes a difference...if not please post back and we´ll look further.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...