Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

Advertise NAT IP via EIGRP

Hi,

How do I advertise a NAT IP internally using EIGRP? The translation happens on the MSFC.

Thanks,

John

  • WAN Routing and Switching
2 REPLIES
Anonymous
N/A

Re: Advertise NAT IP via EIGRP

dynamic routing doesn't work through NAT routers. It's recommendedthat NAT routers be used in stub networks where static or default routes can be used. You can probably work with the Policy based routing or with a route map .

http://www.cisco.com/warp/public/103/14.shtml

Cisco Employee

Re: Advertise NAT IP via EIGRP

Hi,

It depends on what you want to achieve.

In case you want to advertise a NAT pool, just configure one IP as a secondary on an interface and announce it. Make sure your NAT pool does not use the IP (f.e. pool 192.168.1.1 to 192.168.1.253, secondary IP 192.168.1.254/24).

Other than that you could use a static route pointing to the NAT router and redistribute the static.

If the above does not cover your case, please describe in more detail, what you want to achieve and what your topology etc. looks like.

Hope this helps! Please rate all posts.

Regards, Martin

544
Views
5
Helpful
2
Replies