08-19-2013 05:41 AM - edited 03-04-2019 08:48 PM
I currently have a Cisco 851 which I believe does not support MAC ACLs. Does anyone know another device that I can find used that will support them? I would like it to be a small form factor if possible.
Thank You
Solved! Go to Solution.
08-19-2013 08:22 AM
You could use the SG300-10. It's a switch with 10*1Gig interfaces which can also filter on Mac-Adresses:
--
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni
08-19-2013 07:48 AM
2960X
08-19-2013 07:54 AM
Those do not seem to come in the smaller variations like the 800 series. They are also not affordable for a home network.
08-19-2013 08:22 AM
You could use the SG300-10. It's a switch with 10*1Gig interfaces which can also filter on Mac-Adresses:
--
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni
08-19-2013 08:31 AM
That is a great recommendation, but this is a budget project so I was hoping to find something a little older that I can pick up used on eBay. I only need 100Mbps links as well nothing in this network will exceed that. I will keep an eye out for the SG300.. Does the SF300-08 also do Mac address filtering ?
08-19-2013 08:36 AM
Well the SG/SF300 are already "low-end" (at least for Cisco) ... ;-)
I only can confirm it for the SG300, but the Admin Guide is also for the FE-devices and there is nothing mentioned that they don't support it. So I would assume that it will also work on these devices.
--
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni
08-19-2013 08:46 AM
They are low end new. I am looking for low end used
08-19-2013 03:45 PM
I've got a 890 and MAC-based ACL is supported.
Is this low-end for you?
According to the data sheet, 880 will support "MAC filtering", which is essentially MAC-based ACL.
And according to the 860 data sheet, this model does not support MAC-based ACL.
08-19-2013 03:52 PM
But the 880/890 are much more expensive then the SG300-10 (or the SF300-8 which sells for under $100.- on eBay).
--
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni
08-19-2013 03:56 PM
But the 880/890 are much more expensive then the SG300-10 (or the SF300-8 which sells for under $100.- on eBay).
LOL.
But the OP was talking about the 850 router. I'm no expert in the SG-type, but is this a router?
08-19-2013 04:00 PM
no, it's just a SmallBusiness Layer3-switch that could be placed in front of the 850 to do the filtering.
--
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni
08-19-2013 04:03 PM
it's just a SmallBusiness Layer3-switch that could be placed in front of the 850 to do the filtering.
That'll do.
08-20-2013 04:23 AM
Thank you both
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide