Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Aggregate/bond 2xT3(HSSI) lines into one 90M pipe

Is it doable to aggregate/bond 2xT3(HSSI) lines into one 90M pipe? like multilink PPP for NxT1?

Both T3 are on the same router(P-2-P) at each end.

1 REPLY
Silver

Re: Aggregate/bond 2xT3(HSSI) lines into one 90M pipe

I don't know can we aggregate it at L2 but I suggest to use routing protocol to load-sharing two links.

89
Views
0
Helpful
1
Replies