Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

aim atm 2600

Hi all,

i have to setup a 2610XM router to terminate a 8Mb ATM circuit ( 4x E1 AIM ).

I bought:

2610XM

AIM-ATM

2 X VWIC-2MFT-E1

c2600-entservicesk9-mz.124-5a.bin

Now when i try to set the aim to network-clock-partecipet, the router gives me error of unrecognized command.

I check out some configuration and all of them use that command.

can u help me?

sorry for my english

thanks milko

  • WAN Routing and Switching
3 REPLIES

Re: aim atm 2600

hi

As per the datasheet the command network-clock-participate has been introduced in IOS code 12.2(2)XB, so do make sure that you are running either the same or a recent code to have the support for the same.

http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/products_feature_guide09186a00800a18a4.html

regds

New Member

Re: aim atm 2600

i'm using a 12.4 ios

New Member

Re: aim atm 2600

same problem with 12.3 ios

106
Views
0
Helpful
3
Replies