Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AIM-ATM not recognize

Hi,

I'm trying to configure a router in ATM IMA but I have a problem to configure the mode atm ima under the controller.

I installed the ATM IMA module on the mother board but I do a sh diag :

WIC Slot 0:

VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1

Hardware Revision : 0.0

Top Assy. Part Number : 800-22629-05

Board Revision : B0

Deviation Number : 0

Fab Version : 04

PCB Serial Number : FOC11521VCT

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Product (FRU) Number : VWIC2-2MFT-T1/E1

Version Identifier : V01

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF 40 03 FC 41 00 00 C0 46 03 20 00 58 65 05

0x10: 42 42 30 88 00 00 00 00 02 04 C1 8B 46 4F 43 31

0x20: 31 35 32 31 56 43 54 03 00 81 00 00 00 00 04 00

0x30: CB 90 56 57 49 43 32 2D 32 4D 46 54 2D 54 31 2F

0x40: 45 31 89 56 30 31 20 D9 02 40 C1 FF FF FF FF FF

0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

and my version is Version 12.4(3h)

and sh ver 2 FastEthernet interfaces

2 Channelized (E1 or T1)/PRI ports

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62720K bytes of ATA CompactFlash (Read/Write)

Can you advice me, please.

2 REPLIES
New Member

Re: AIM-ATM not recognize

I upgraded from 12.4(3H) to 12.4(11)T4 thinking that it might take care of the problem but now I see in the sh diag CLI

my ATM IMA module but when I do a sh ver I don't see the module AIM. And still I can't configure atm ima on the controller.

card type e1 0 0

network-clock-participate wic 0

network-clock-select 1 E1 0/0/0

network-clock-select 2 E1 0/0/1

yourname(config)#controller E1 0/0/0

yourname(config-controller)#mode ?

cas Configure CAS (Channel Associated Signal) mode

ccs Configure CCS (Common Channel Signal) mode

Hall of Fame Super Gold

Re: AIM-ATM not recognize

Which exact IOS are you running?

You might need "SP services" or "advanced IP services" image for ATM IMA.

Hope this helps, please rate post if it does!

108
Views
0
Helpful
2
Replies