cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
316
Views
0
Helpful
1
Replies

AIM-ATM to NM-ATM module

Corey OBrien
Level 1
Level 1

we have been using the NM-ATM mods without issue but they are now discontinued. I am trying to use an AIM-ATM mod with at VWIC-2MFT-T1 card and connect to a NM-ATM interface on the other side. the aim-atm side clears with no alarm but the nm-atm side still alarms. wondering if there is a compatibility issue?

1 Reply 1

sbilgi
Level 5
Level 5

To further look into this issue, can you send me a brief overview of your network setup?. Or, it would be even better if you can send me your network topological diagram. Because, with some clear information, I will be able to guide you confidently.

Also, send me the configurations you have made in all your devices. Example is a show tech output.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card