Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AIM-ATM to NM-ATM module

we have been using the NM-ATM mods without issue but they are now discontinued. I am trying to use an AIM-ATM mod with at VWIC-2MFT-T1 card and connect to a NM-ATM interface on the other side. the aim-atm side clears with no alarm but the nm-atm side still alarms. wondering if there is a compatibility issue?

1 REPLY
Silver

Re: AIM-ATM to NM-ATM module

To further look into this issue, can you send me a brief overview of your network setup?. Or, it would be even better if you can send me your network topological diagram. Because, with some clear information, I will be able to guide you confidently.

Also, send me the configurations you have made in all your devices. Example is a show tech output.

112
Views
0
Helpful
1
Replies