Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Annoying Issue with DMVPN tunnel connections

Good morning. I have been suffering through an issue with our DMVPN tunnels for the last year or more and finally decided to try and get some help.

The issue is if a tunnel goes down it does not always recreate itself automatically. I need to telnet to the routers serial interface and do the following command on the tunnel interface. "no tunnel key 10000" then I put the tunnel key back in and the tunnel gets created.

I am looking at rolling this out across many different sites if I can solve this issue.

Hardware at the remote sites are 1711 router with IOS 12.3(7)XR6 and the headend router is a 3825 with IOS 12.3(11)T9.

The remote site is working with a static ip asigned to its outside ethernet interface.

Thanks for all the help.

2 REPLIES

Re: Annoying Issue with DMVPN tunnel connections

Hi,

Thus your configuration have more than one tunnel interface using the same tunnel source address?

Dandy

New Member

Re: Annoying Issue with DMVPN tunnel connections

Right this location has a subnet routed to one location and all other traffic back here to corp.

98
Views
0
Helpful
2
Replies