Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Any way to convert unicast to multicast??

My customer has a Hoot n Holler application on their entreprise that consists of 7936s plugged into fxs ports which PLAR to a VoIP dial-peer with "session protocol multicast" and that, of course, gets multicast around the enterprise.

So my challenge is that I have a new remote site with a C881 with universal code. It supports voice and multicast, but come to find out the hard way, there isn't a "session protocol" option for multicast. Cisco is saying that it multicast is not supported for dial-peers on the C881 yet but is road-mapped. My question: can anyone think of any alternatives- perhaps something to the effect of PLARing the fxs to an MTP that could multicast, or converting uni-cast to multi-cast, or anything?

I'm at a loss........and I'm stuck in Minneapolis because of it......

THANKS!

1 REPLY
1268
Views
4
Helpful
1
Replies