Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Anyone seen this before?

Router(config)#int atm0/0/0.608

Router(config-subif)#pvc 1/608

% Incomplete command.

Router(config-subif)#pvc 1/608 ?

% Unrecognized command

Cisco IOS Software, 1841 Software (C1841-SPSERVICESK9-M), Version 12.4(13a), RELEASE SOFTWARE (fc1)

3 REPLIES
Hall of Fame Super Bronze

Re: Anyone seen this before?

Did you define that subinterface as point-to-point?

For instance:

Router(config)#int atm0/0/0.608 point-to-point

Can you post the show config along with the show diag output?

Regards

Edison.

New Member

Re: Anyone seen this before?

WIC/HWIC Slot 0:
        GSI GSHDSL MULTI LINE ATM WIC

        Hardware Revision        : 0.0
        Top Assy. Part Number    : 800-26571-02
        Board Revision           : C0
        Deviation Number         : 0
        Fab Version              : 01
        PCB Serial Number        : FOC11276H30
        RMA Test History         : 00
        RMA Number               : 0-0-0-0
        RMA History              : 00
        Version Identifier       : V02
        Product (FRU) Number     : WIC-1SHDSL-V3
        EEPROM format version 4
        EEPROM contents (hex):
          0x00: 04 FF 40 04 DA 41 00 00 C0 46 03 20 00 67 CB 02
          0x10: 42 43 30 88 00 00 00 00 02 01 C1 8B 46 4F 43 31
          0x20: 31 32 37 36 48 33 30 03 00 81 00 00 00 00 04 00
          0x30: 89 56 30 32 20 CB 8D 57 49 43 2D 31 53 48 44 53
          0x40: 4C 2D 56 33 FF FF FF FF FF FF FF FF FF FF FF FF
          0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
          0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
          0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF


controller DSL 0/0/0
mode atm
line-term cpe
line-mode auto
dsl-mode shdsl symmetric annex B


interface ATM0/0/0
no ip address
no atm ilmi-keepalive
!
interface ATM0/0/0.608 point-to-point

description

ip address x.x.x.x y.y.y.y

New Member

Re: Anyone seen this before?

Problem solved

for some reason that WIC had the following

Router(config-if)#pvc ?
<0-31> Enter VPI/VCI value(slash required)
<1-255> Enter VCI value

using atm vc-per-vp 2048 the range was extended and it accepted the 608 value

258
Views
0
Helpful
3
Replies