I have implemented a network where 2 sites are connected through 1 router 3660 on each by 2 mbps leased line. Pix 515 firewall is placed at LAN on both ends. Intervlan routing is done by PIX. Pix inside, outside & router Ethernet interfaces is getting connected to Cisco 2950 Layer 2 switch. The same configuration is happen on end point. 2 vlans(user & server) has made on pix & advertised over 2950 switches. Server security zone is 75 & users is 50. Every end requires access to server vlan of another end & user vlan is only user for accessing local resources. Currently for accessing any server, I open IP to IP permission on PIX at both ends. Now all required servers & applications are accessing through both point apart from Hummingbird Exceed Application Thats run on SUN server. We can ping Sun server IP address & access it. If I remove PIX at any end & place intervlan routing through router, then I get access to exceed application. Pls. give me resolution whether its a network or application problem.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.