Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Applique type is Subrate T3, should be a full T3

hello

i Have a Cisco 3845 ISR with a NM-1t3 network module installed. When I do a "show controllers t3 1/0" command the Applique type is Subrate. This line is a full 45Mbps. Anyone know why it would be showing Applique type is Subrate.

Many Thanks

1 REPLY
Hall of Fame Super Gold

Re: Applique type is Subrate T3, should be a full T3

Hi,

Applique and subrate are terms derived from other routers hardware, and the code of "show controller" has not been changed since. You can be reassured that your full T3 line is being used as such.

Hope this helps, please rate post if it does

466
Views
0
Helpful
1
Replies