I'm trying to figure out what router would be able to route fast enough to handle a 100Mb WAN circuit. I was reading the 3800 series router blurb which says "Built for performance, the Cisco 3800 Series routers deliver multiple concurrent services up to wire-speed T3/E3 rates". I don't know if that means it can handle the equivalent of multiple 45Mb circuits or a total of 45Mb.
I'm told this circuit will be delivered to us as standard 100Mb Ethernet using an RJ-45 connection. I was wondering if it would be dumb to just use a switch seeing as they seem to most of the features of a router these days.
If you are using 100 MB as your WAN link, it would most probably be a fiber link rather than a standard RJ45 connection. We have 100 MB internet link on one of our routers. Its using a fiber connection and the router model used is Cisco 3825.
If you want to get any interface of upto 100 Mbps, you should you ahead with 7200 VXR with atleast NPE-G1 (which can take care of 100Mbps Interfaces and the processing speed required by the processor).
Furthermore, you may confirm the same by visiting the Data Sheets at
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...