1)I Have to know where/when in OSPF We use the command area x default-cost
To specify a cost for the default summary route sent into a stub or not-so-stubby area (NSSA), use the area default-cost command in router configuration mode. To remove the assigned default route cost, use the no form of this command.
area area-id default-cost cost
no area area-id default-cost cost
Identifier for the stub or NSSA. The identifier can be specified as either a decimal value or as an IP address.
Cost for the default summary route used for a stub or NSSA. The acceptable value is a 24-bit number.
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
The command is used only on an Area Border Router (ABR) attached to a stub or NSSA.
There are two stub area router configuration commands: the stub and default-cost options of the area command. In all routers and access servers attached to the stub area, the area should be configured as a stub area using the stub option of the area command. Use the default-cost option only on an ABR attached to the stub area. The default-cost option provides the metric for the summary default route generated by the ABR into the stub area.
Note To remove the specified area from the software configuration, use the no area area-id command (with no other keywords). That is, the no area area-id command removes all area options, such as area authentication, area default-cost, area nssa, area range, area stub, and area virtual-link.
The following example assigns a default cost of 20 to stub network 10.0.0.0:
Setting the metric-type to 1 is useful when there are multiple paths/ABRs exist for the traffic leaving the network. The internal routers would be able to choose the optimal path via the closest ABR to reach the destination network. Metric type 1 would cause the cost of the route increment as it travels through every additional hop and thus any router with multiple path(s) to a network would choose the one with a lower cost/better metric. On the other had, with metric-type 2 the cost remains constant and the internal routers mayn't make the best choice of path. As you can see, metric-type 1 would be useful only when there are multiple ABRs exist in your network.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...