Are we correct in assuming that you are connected directly on the console port of the 5300? When you change the baud rate in hyperterm did you stop and start the hyperterm session? I suggest that you stop and restart hyperterm and see if it clears up the problem. If it does not then there may be some mismatch between what the console speed really is and what you think that it is. I would then suggest that you try each of the console speeds, being sure to stop hyperterm and start it again each time you specify a different speed.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...