01-07-2008 04:23 AM - edited 03-03-2019 08:09 PM
I am using Cisco AS5300 with IOS 'c5300-is-mz.123-6.bin'. Whenever the AS reboots (abnormally, e.g. power recycle), it stuck in ROM mode. Then there is a need to hard reset the AS, OR reset the AS through console.
Is there any other way? upgrading IOS? etc.
Thanks in advance
01-07-2008 12:52 PM
I haven't used an AS5300 in a while, but this *sounds* like a configuration register problem. Don't remember the setting but the config reg is a bitmap, the bit that says "boot to IOS" must be OFF. Someone here should know...
Paul
01-08-2008 06:17 AM
This is not config register issue. It's 0x2102 (boot from IOS)
Any other ideas?
01-08-2008 09:13 AM
Then I'd say TAC case it...
03-04-2009 04:50 AM
Hi,
I have same experience with as53500.
Have you find any solution for this problem.
Thank in advance,
03-04-2009 06:12 AM
Hi,
Unfortunately not :(
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: