Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AS5300 stuck in ROM mode

I am using Cisco AS5300 with IOS 'c5300-is-mz.123-6.bin'. Whenever the AS reboots (abnormally, e.g. power recycle), it stuck in ROM mode. Then there is a need to hard reset the AS, OR reset the AS through console.

Is there any other way? upgrading IOS? etc.

Thanks in advance

5 REPLIES

Re: AS5300 stuck in ROM mode

I haven't used an AS5300 in a while, but this *sounds* like a configuration register problem. Don't remember the setting but the config reg is a bitmap, the bit that says "boot to IOS" must be OFF. Someone here should know...

Paul

New Member

Re: AS5300 stuck in ROM mode

This is not config register issue. It's 0x2102 (boot from IOS)

Any other ideas?

Re: AS5300 stuck in ROM mode

Then I'd say TAC case it...

New Member

Re: AS5300 stuck in ROM mode

Hi,

I have same experience with as53500.

Have you find any solution for this problem.

Thank in advance,

New Member

Re: AS5300 stuck in ROM mode

Hi,

Unfortunately not :(

122
Views
0
Helpful
5
Replies