Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

AS5350XM and NP108, can't configure DSP, how to?

Hi folks,

I have one AS5350XM with the following (taken from sh inventory):

* E1 8 PRI DFC

* NP108 VUFC

So far I have read from the cisco documentations, I should get configured DSP on the router with the command: "voice dsp slot/dsp slot/dsp" but whenever I try to put the command it shows error like it doesn't have DSP:

--------------------------------------------

HQ-RTR(config)#voice dsp ?
% Unrecognized command
HQ-RTR(config)#voice dsp

---------------------------------------------

I just killed my whole day to get it understand why it's not giving me privilege to configure. I am using IOS: c5350-js_ivs-mz.124-24.T.bin

To get more understand i am giving some necessary command outputs:

-------------------------------------------------------------------------------------------------

HQ-RTR#sh inventory
NAME: "AS5350XM chassis", DESCR: "AS5350XM chassis"
PID: AS535XM-AC-PWR    , VID: V02, SN: XXXX

NAME: "SPE_1", DESCR: "NP108 VUFC, "
PID:                   , VID:    , SN: XXXX

NAME: "SPE_2", DESCR: "NP108 VUFC, "
PID:                   , VID:    , SN: XXXX

NAME: "E1_3", DESCR: "E1 8 PRI DFC, HwVer#: 4.8"
PID:                   , VID:    , SN: XXXX

HQ-RTR#sh voice dsp detailed

DSP  DSP                DSPWARE CURR  BOOT                         PAK     TX/RX
TYPE NUM CH CODEC       VERSION STATE STATE   RST AI VOICEPORT TS ABORT  PACK COUNT
==== === == ======== ========== ===== ======= === == ========= == ===== ============

HQ-RTR#

-------------------------------------------------------------------------------------------------------------------------------------------------------------------------

I need your help if I am missing something to configure anything, I am just stuck at this point on my CCIE study.

Everyone's tags (3)
1 REPLY
Hall of Fame Super Silver

Re: AS5350XM and NP108, can't configure DSP, how to?

Hello Bilashece,

see

http://www.cisco.com/en/US/docs/routers/access/as5350/software/configuration/guide/54bas2.html#wpxref24219

the command you would like to apply may be not available on this specific platform that is an access server.

Hope to help

Giuseppe

1192
Views
0
Helpful
1
Replies