I have created a successful IpSEC VPN tunnel between a Linksys RVL200 and ASA 5505 using the Site to Site VPN Wizard. After settings on both devices are matching, the tunnel connects but a client software on the remote site cannot use port 3306. Do I have to configure additional ACl / ACE policies to make the traffic enabled? I assumed (because I am a newbie) that once the private tunnel is establoshed, all traffic is allowed on the interfaces. I spoke to a L1 technician at the hosting facility and they said that the configuration needs tweaking because it is "dropping packets". The client software works perfectly fine when the RVL200 is connected to an RVL200 via an ipsec tunnel - so the only thing I changed was the ASA device.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...