I buy the ASA 5505 firewall and wish to replace the existing PIX 506iE firewall.
In the old topology; there are only inside network 192.168.1.0/24 for server only and 202.**.***.217 is outside public interface. In the old setting, one server map one public ip by static NAT for public access and no other user connect to firewall.
I read the manual of ASA 5505 and it suggest put the server in DMZ but I do not wish to change the network topology. Is it OK for map the outside public IP to inside private IP without using DMZ in ASA5505? Is the setting same as PIX 506iE?
The instructions you have read on asa5505 are the recommended guideline topology scenario using DMZ to place your server isolated from your private network that will be accessed from the outside public inter-network.
You can however do the static NAT mappings the same way you had it before when using PIX506E without using DMZ network.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...