Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA 5520 dual WAN (Interface 1 and Interface 2) connection settings

Hi dear,

I have attached setup like this  :-

This is the same scenarioa as ASA with Dual WAN setup. But my requirement is different. I have added in ASA and configure sla is asa, all working fine. When one link goes down traffic passs through backup route. my sal config is below:-

sla monitor 100

type echo protocol ipIcmpEcho 10.5.5.120 interface Link1

num-packets 3

frequency 10

sla monitor schedule 100 life forever start-time now

=======

show runn routes are :-

route Link1 10.5.5.0 255.255.255.0 10.4.4.5 1 track 10

route Link2 10.5.5.0 255.255.255.0 10.6.6.5 254

Is there any way that i can implement track on 2nd link to destination? because may be after Link1 failure when backup route was it would be able pass traffic to destination, may be link failure between Link router and Destination. Can i monitor backup link if that is active and traffice can pass to destination when 1st Link1 will fail.

Hope u will help me,

AB

1 REPLY
New Member

Re: ASA 5520 dual WAN (Interface 1 and Interface 2) connection s

sorry

I explain here:-

This is the same scenarioa as ASA with Dual WAN setup. But my requirement is different. I have added in ASA and configure sla is asa, all working fine. When one link goes down traffic passs through backup route. my sal config is below:-

sla monitor 100

type echo protocol ipIcmpEcho 10.5.5.120 interface Link1

num-packets 3

frequency 10

sla monitor schedule 100 life forever start-time now

=======

show runn routes are :-

route Link1 10.5.5.0 255.255.255.0 10.4.4.5 1 track 10

route Link2 10.5.5.0 255.255.255.0 10.6.6.5 254

Is there any way that i can implement track on 2nd link to destination? because may be after Link1 failure when backup route was choosen it would be able pass traffic to destination, may be link failure between Link router and Destination. Can i monitor backup link if that is active and traffice can pass to destination when 1st Link1 will fail.

How i can assure that Backup link (Link2) can access destination? This is my problem

Hope u will help me,

AB

526
Views
0
Helpful
1
Replies