Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

ASA Captures

How do I configure a wireshark capture on the ASA?

5 REPLIES
New Member

Wireshark?!?Isn't enough the

Wireshark?!?

Isn't enough the logging on the ASA?

 

Or in case, you can send the logs to an external syslog for further analyzing on it (also wireshar). But this is depending of which tools on syslog you're using.

 

regards

New Member

What is the issue and what

What is the issue and what are you trying to check?

Hi, You can use this link to

Hi,

 

You can use this link to set up captures then, export them and analyze them on Wireshark:

https://supportforums.cisco.com/document/69281/asa-using-packet-capture-troubleshoot-asa-firewall-configuration-and-scenarios

 

Please don't forget to rate and mark as correct the helpful Post!

 

David Castro,

Regards,

New Member

Use the Packet Capture wizard

Use the Packet Capture wizard. After you stop your capture, there is a button to "Save Captures" that will bring up another box asking for the save type as "Text" or "PCAP". Save it as a PCAP then open it with Wireshark.

 

If this is not what you are wanting, let us know.

 

Also, See this link, it may help.

http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/118097-configure-asa-00.html

 

Please don't forget to rate and mark as correct the helpful Post!

 

Thanks

Brian W

New Member

Create your capture

Create your capture

enter the following command...

https://X.X.X.X/capture/testcap/pcap

Where X is the IP Address of the inside interface

78
Views
0
Helpful
5
Replies
CreatePlease to create content