I'm quite new in ASA administration, and I have a question regarding a NAT configured with ASDM. I have 10.250.32.0/32 network in wich I did a NAT to reach a 172.22.250.0 network. At this moment I'm trying to create another NAT translation over the same 10.250.32.0 network but the translation should be in other network but the previous NAT should stay intact. when I try to configure that in ASDM I get a message telling me that NAT translation already exists.
How can I resolve this problem in ASDM? if you need any screenshot or "show run" line, there will be no problem.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...