Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASR 10002-X IOS upgrade problem TFTP timing out

Hello

 

I have TFTP server running

I can ping between router and laptop

Both interfaces are hard coded for gig/full

There is (6001291264 bytes free) on ASR

Image is asr1002x-universalk9.03.12.01.S.154-2.S1-std.SPA.bin (401,851kb)

I use copy tftp: bootflash: command

 

ASR1002x#copy tftp: bootflash:
Address or name of remote host []? 1.1.1.2
Source filename []? asr1002x-universalk9.03.12.01.S.154-2.S1-std.SPA.bin
Destination filename [asr1002x-universalk9.03.12.01.S.154-2.S1-std.SPA.bin]?
Accessing tftp://1.1.1.2/asr1002x-universalk9.03.12.01.S.154-2.S1-std.SPA.bin...
%Error opening tftp://1.1.1.2/asr1002x-universalk9.03.12.01.S.154-2.S1-std.SPA.bin (Timed out)
MMC-ASR1002x#

 

Please provide some expert guidance on how to resolve this.

 

 

 

 

sMc
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Very difficult to say without

Very difficult to say without further debugging, but one thing that does spring to mind is the management VRF on the ASR. If you are using the Gig0 interface on the ASR, make sure that you have the config listed at:

http://www.cisco.com/en/US/docs/routers/asr1000/configuration/guide/chassis/Management_Ethernet.html#wp1065360

 

2 REPLIES
Cisco Employee

Very difficult to say without

Very difficult to say without further debugging, but one thing that does spring to mind is the management VRF on the ASR. If you are using the Gig0 interface on the ASR, make sure that you have the config listed at:

http://www.cisco.com/en/US/docs/routers/asr1000/configuration/guide/chassis/Management_Ethernet.html#wp1065360

 

New Member

mfaggion Thank you for the

mfaggion

 

Thank you for the response. May best to just use the management int, gi0, for this?

I am currently using Gi0/0/5

sMc
201
Views
0
Helpful
2
Replies