ASR 1001 HIGH DELAY WITH SHOW IP CACHE FLOW COMMAND
We recently have changed a 7206VXR router with NPE-10G processor with a ASR 1001.
This ASR 1001 router have the following specification:
System restarted at 16:12:46 UTC Wed Feb 27 2013 System image file is "bootflash:/asr1001-universalk9.03.06.00.S.152-2.S.bin" Last reload reason: Reload Command
Next reload license Level: adventerprise
cisco ASR1001 (1RU) processor with 1163580K/6147K bytes of memory. Processor board ID SSI163204CZ 4 Gigabit Ethernet interfaces 32768K bytes of non-volatile configuration memory. 4194304K bytes of physical memory. 7741439K bytes of eUSB flash at bootflash:.
Configuration register is 0x2102
the problem we have with this router is thet when we excute the command: show ip cache flow | include 10.41.238.x the ressults delay to appear more than 2 minutes.
Can you tell me if this high delay to show me the results is normal?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...