Hi I am changing IOS of Cisco ASR 1001 from asr1001-universalk9.03.07.02.S.152-4.S2.bin
to asr1000rp1-adventerprisek9.03.04.02.S.151-3.S2.bin but everty time it boot up with old IOS universalk9.
Is it becaused of Licence issue.
Router#sh bootvar BOOT variable = bootflash:asr1000rp1-adventerprisek9.03.04.02.S.151-3.S2.bin,12;bootflash:asr1001-universalk9.03.07.02.S.152-4.S2.bin,12; CONFIG_FILE variable does not exist BOOTLDR variable does not exist Configuration register is 0x2102
cisco ASR1001 (1RU) processor with 1155941K/6147K bytes of memory. Processor board ID SSI1607042B 4 Gigabit Ethernet interfaces 32768K bytes of non-volatile configuration memory. 4194304K bytes of physical memory. 7741439K bytes of eUSB flash at bootflash:.
You downloaded the wrong file. The file you wanted to run has "rp1" but the original file doesn't. You downloaded a file for a different model. Your router is an ASR 1001 with fixed RP but you've downloaded a file for a different sub-model of ASR, like the 1002 or 1004.
Go here instead: http://software.cisco.com/download/release.html?mdfid=282993672&softwareid=282046477&release=3.10.3S&relind=AVAILABLE&rellifecycle=ED&reltype=latest
in addition to that, it seems like a downgrade rather than upgrade. Once you have the correct image, you need to change the boot system command to use the new image and negate the old one, or add it (the old one back) after, to have backup image in case it fails.
Please rate useful posts & remember to mark any solved questions as answered. Thank you.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...