That documentation assumes that you can create a VLAN interface on an ASR 1001 or 1002. I have both and you cannot create them. Another post mentioned doing a BDI interface but you still do not get the xconnect vfi for an attachment point.
hi ,can we configure VLAN on the built in GE in ASR1002 and ASR1001 ,Can have subinterfacees on the built in GE interfaces and also configure Dot.1q for each customer with VRF on the subunterface,? also can we configure Xconnect for each customer on the subinterface (vlan, dot.1q)?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...