Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASR 1002 management interface

Has anyone noticed any physical problems with the management interface on the ASR line (1002 in particular)?

We move the cable just a small amount, and the link light goes out.

Logical config/setup is correct.  We've burned through a pile of cables, same behavior. 

Have you seen a router that makes you wonder if there is a bad solder joint, bad socket, etc?

Thanks,

David

Everyone's tags (4)
1 REPLY
New Member

I just purchased 12 x ASR

I just purchased 12 x ASR 1002 routers and have this problem will all of them.  I had to secure the Ethernet cable with a zip-tie to the side to ensure there is link.  It appears to be a problem with the port as the cable is very loose.  

Very Frustrating.  See Attached.

 

179
Views
0
Helpful
1
Replies