Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASR 1004 and persistent SSH

Hi.

Im trying to configure persistent SSH across management Interface in our new Cisco ASR 1004 platforms. Well, It seems to work fine, however when I try ssh to management interface:

1. TACACS+ authentication doesn´t work. Only local authentication (usernames configured in local) works with persistent SSH. Taking a view to ASR 1004 user guide, aaa is not supported over management interface configured for persistent SSH. Ok, it´s clear for me.

2. SSH session is stuck waiting for free TTY line, but only I´m trying to access to it ¿¿??. I only get into router emulation using persistent SSH, in diag mode pressing Ctrl+C or Ctrl+Shift+6, but you know in diag mode we won´t obtain full line vty capabilities. Anybody knows why don´t we obtain TTY line access using persistent SSH?

This is our config:

transport-map type persistent ssh sshmg
rsa keypair-name ASR_CBR4.elcorteingles.es
transport interface GigabitEthernet0
banner wait "*** WAITING FOR VTY LINE - CBR4***"
banner diagnostic "***DIAGNOSTIC MODE - CUBR4***"
connection wait allow interruptible

transport type persistent ssh input sshmg

B.R.

2.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

ASR 1004 and persistent SSH

2 REPLIES
Cisco Employee

ASR 1004 and persistent SSH

Hall of Fame Super Silver

ASR 1004 and persistent SSH

Nick

I am delighted to see that you have begun to post in the CSC. Welcome Aboard.

HTH

Rick

2585
Views
0
Helpful
2
Replies
CreatePlease to create content