Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

ASR 1004 with backup interface command

Hi,

I have a ASR 1004 with the following int:

1 x Cisco 8-Port   Gigabit Ethernet Shared Port Adapter
2 x Cisco 1-Port 10GE LAN-PHY Shared Port Adapter

1. Can I do a backup int in 1 of the 8 Port gigabit ethernet port to backup another port in the same module?

2. Can I do a backup int in 1 of the 10G Port gigabit port to backup the other 10Gb port?

My topology is as below:

ASR 1004 -- Switch A

      |                  | L2 trunk

      |----------- Switch B

Is there a config guide for this?

458
Views
0
Helpful
0
Replies
CreatePlease to create content