Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASR 9K IP-SLA Track config

Hİ,

Anyone knows how to config ASR 9K to do IP-SLA and Track config as we do in regular IOS. Somehow I am unable to get track command after static route. I believe there should be a way to get it done.

I use this config for WAN redundancy scenarios.

here is an example from a 7600 router.

ip sla 1
icmp-echo 10.1.1.1

ip sla schedule 1 start-time now

track 1 rtr 1 reachability


ip route 10.100.100.0 255.255.255.0 192.168.1.1 track 1

11 REPLIES

ASR 9K IP-SLA Track config

New Member

Re: ASR 9K IP-SLA Track config

Checked it out, still could not find a way to remove 10.100.100.0 from routing table when router can not ping 10.1.1.1.

Bronze

ASR 9K IP-SLA Track config

can you try this;

ip route 10.1.1.1 255.255.255.255 serial0/0

hth

Muammmer

New Member

ASR 9K IP-SLA Track config

dont understand how this is going to help me, i guess using an interface got you confused. I updated the question.

Bronze

ASR 9K IP-SLA Track config

Hi,

     You can check a line’s status via ip sla configuration and if there is a problem (for example downing of the line, packet loss… etc.) you provide that the traffic can flow over the other line. Meanwhile you continue to check the status of the first line and when the problem is solved you provide to return to the old status again. you can do this simply by pinging an ip adres by using the first line, here is a static route for this as mentioned below.

ip route 10.1.1.1 255.255.255.255 serial0/0

hth

Muammer

New Member

ASR 9K IP-SLA Track config

Thank you for the info I am actually well aware of.

Checking line stat is not an option for ME and GHSDSL and some LL running FR. As you would probably know even the circuit is broken somewhere the int will not go down so if I use a static route I have a bad redundancy scenario.

And the other thing is I need to do is on ASR 9K running Cisco IOS XR not regular IOS…

I have done some search already and checked the pdf Smitesh suggested and no answer yet.

ASR 9K IP-SLA Track config

Hi,

Alternately you can use EEM which tracks the IP SLA / TRACK and depending upon its reachability it removes/add the configuration from the running-config.

HTH,

Smitesh

ASR 9K IP-SLA Track config

New Member

ASR 9K IP-SLA Track config

Hi,

do you know if it is possible (ASR 9K v4.2.3) to tear down an L2 interafce by trackink another L2 interface?

regrads

New Member

ASR 9K IP-SLA Track config

i am writing a  script to remove or add the configuration depending on the tracks status. the script is ready but i'm having a problem with eem variable cli_open. ıf you could solve my problem we could have a solution.

New Member

ASR 9K IP-SLA Track config

Hi Guys,

any of you knows if it is possible to tear down an L2 interface (ASR 9k v4.2.3) by tracking another L2 interface?

Regards

Ale

1771
Views
0
Helpful
11
Replies