Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASR1000 EVC Binding L3-Service to BDI, unable to configure Int VLAN

Hi I have configured two EFP into one Bridgedomain with Bridge DomainID 44.

Now I want to have a L3 interface in the BD, as I know from other platforms this is done by configuring

SVI 44 which is associated with BDI 44, so far so good, unfortunately its not possible to configure

the SVI 44, though the parser shows it as an option. Should be also supported on ASR1000 running 3.11,

I could not see another way to enable L3 Service for a BDI

Thx

Hubert

interface GigabitEthernet0/0/0

description **--Ethernet-Backbone A-**

backup interface GigabitEthernet0/0/1

no ip address

negotiation auto

service instance 44 ethernet

  encapsulation dot1q 44 vlan-type 0x9100

  rewrite ingress tag pop 1 symmetric

  bridge-domain 44 split-horizon group 0

!

!

interface GigabitEthernet0/0/1

description **--Ethernet-Backbone B-**

no ip address

negotiation auto

service instance 44 ethernet

  encapsulation dot1q 44 vlan-type 0x9100

  rewrite ingress tag pop 1 symmetric

  bridge-domain 44 split-horizon group 0

!

!

show bridge-domain 44

Bridge-domain 44 (2 ports in all)

State: UP                    Mac learning: Enabled

Aging-Timer: 300 second(s)

2 ports belonging to split-horizon group 0

    GigabitEthernet0/0/0 service instance 44 (split-horizon)

    GigabitEthernet0/0/1 service instance 44 (split-horizon)

   MAC address    Policy    Tag     Age Pseudoport

!

Router(config)#int vlan ?

  <1-4095>  Vlan interface number

Router(config)#int vlan 44

                    ^

% Invalid input detected at '^' marker.

Router(config)#

Leider kann ich so auf die BDI kein Layer 3 binden, hab keine Idee L

interface Vlan44

ip address 172.16.254.1 255.255.255.0

Everyone's tags (5)
1 REPLY
Silver

ASR1000 EVC Binding L3-Service to BDI, unable to configure Int V

According to this document it looks like the syntax is interface bdi instead of interface vlan.

http://www.cisco.com/en/US/docs/routers/asr1000/configuration/guide/chassis/bdi_ps9343_TSD_Products_Configuration_Guide.html#wp1141221

Daniel Dib
CCIE #37149

Please rate helpful posts.

Daniel Dib CCIE #37149 Please rate helpful posts.
496
Views
0
Helpful
1
Replies