10-23-2013 08:08 AM - edited 03-04-2019 09:23 PM
Hello,
I wants to bundle 2 of the ASR1001 interfaces to a Portchannel using lacp.
In this portchannel we wants to use vlans and vrf and ospfv2.
So the ASR 1001 should behave like a switch with a portchannel with several vlans on it.
So the resulting config will look like this on the asr1001
!
ip vrf a
rd 1:1
ip vrf b
rd 2:1
!
interface GigabitEthernet1/0/0
no ip address
negotiation auto
channel-group 1
!
interface GigabitEthernet1/0/1
no ip address
negotiation auto
channel-group 1
!
interface Port-channel1
!
interface Port-channel1.10
ip vrf forwarding a
ip address 10.0.10.1 255.255.255.0
encapsulation dot1Q 10
ip ospf 1 area 10
ip ospf multi-area 11
!
interface Port-channel1.20
ip vrf forwarding a
ip address 10.0.20.1 255.255.255.0
encapsulation dot1Q 20
ip ospf 1 area 20
ip ospf multi-area 21
!
router ospf 1 vrf a
network 10.0.10.0 0.0.0.255 area 0
!
router ospf 1 vrf b
network 10.0.20.0 0.0.0.255 area 0
I searched the web, but i did not find any examples, which confirms, this will work this way.
I have only found this document, which goes into this direction:
http://www.cisco.com/en/US/docs/ios-xml/ios/lanswitch/configuration/xe-3s/asr1000/lnsw-flow-portchannel-load.html
or this one, not sure for which platform this was written:
http://www.cisco.com/en/US/docs/ios/lanswitch/configuration/guide/lsw_cfg_gecvlan_ps9587_TSD_Products_Configuration_Guide_Chapter.html
I can not test it anywhere at the moment, and i want to decide, if this router is usable for this scenario or not.
Solved! Go to Solution.
10-23-2013 10:06 PM
Hi,
I confirm that the ASR1K device can be used to implement the above configuration.
***********Plz do rate this post if you found it helpful*************************
Thanks & Regards,
Vignesh R P
10-23-2013 10:06 PM
Hi,
I confirm that the ASR1K device can be used to implement the above configuration.
***********Plz do rate this post if you found it helpful*************************
Thanks & Regards,
Vignesh R P
10-24-2013 02:32 AM
Hi,
Meanwhile i have found a ASR1k for testing. It works indeed. Some syntaxerrors in the config, but technicaly it works.
Regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: