Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

ASR1002 bridging

Hello,

I have a ASR1002 router which i needs to connect it with two firewalls. Can someone give a solution for this?

I tried to use bridging, but bridging is not supported I believe.

Appreciate your help.

Thameem

  • WAN Routing and Switching
1 REPLY
New Member

ASR1002 bridging

Hello Thameem,

The ASR supports 802.1q encapsulation on sub-interfaces. It's also possible to create Layer 3 port-channels with the ASR.

The sub-interface configuration example is below -

interface F0/0/.100

encapsulation X <--- VLAN tag value

ip address x.x.x.x

The port-channel configuration example -

interface Gi0/0/0

channel-group 1 mode active

!

interface Gi0/0/1

channel-group 1 mode active 

!

interface port-channel 1

ip address x.x.x.x

!

Hope this helps,

Jesse

289
Views
0
Helpful
1
Replies
This widget could not be displayed.