Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

asr1004 configure to upgrade image from G0

  Hi

I have asr1004, and currently only G0 (management port connected).

I have put:

ip tftp source-interface GigabitEthernet0

ip ftp source-interface GigabitEthernet0

ip scp server enable

but, I have ok to get tftp connection, and the file maybe  too big, so could not be downloaded. and ftp/scp all compain "Destinationunreachable".

of course, from the box, I can not ping tftp server.

configuration related are:

interface GigabitEthernet0

vrf forwarding Mgmt-intf

ip address 10.1.1.2 255.255.255.0

nogotiation auto

no mop enabled

ip route vrf Mgmt-intf 0.0.0.0 0.00.0 10.1.1.1 permanent

And aaa new-model with all setup commands to make ssh working are configured. I can ssh into box from tftp server, and I can "wr net" to copy running configure to tftp server.

But "copy scp: bootflash:"  and "copy ftp: bootflash:" complains - no gataway.

Could any one advice me how can I scp image to box?

And can I change interface G0 to a normal interface by remove "vrf forwarding Mgmt-intf"?

Any comments will be appreciated

Thanks in advance

julxu

  • WAN Routing and Switching
225
Views
0
Helpful
0
Replies