Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

assign a default route on MGX 8850 PXM1E

Hi!

im unable to telnet to my remote mgx disk ip address. from the LAN side i can telnet to it but remotely i can't. I noticed on my other MGX, there is an entry on ROUTE NET TABLE (using routeshow cmd)

destination gateway ... interface

0.0.0.0 192.168.x.x lnPci0

would anybody know how this was done?

Many thanks!!

2 REPLIES

Re: assign a default route on MGX 8850 PXM1E

hi

i read one documet. in this they have configure using

ip route 0.0.0.0 0.0.0.0 W.X.Y.Z 1

you can have this link

http://www.cisco.com/en/US/products/hw/switches/ps1938/products_configuration_guide_chapter09186a00800df276.html

hope this willhelp you

regards

Devang

Community Member

Re: assign a default route on MGX 8850 PXM1E

Thanks!

i've read this article before but the default route refers to the Router Module. the 0.0.0.0 route refered i was referring to was for the PXM only. Thanks still for yoru reply!

110
Views
0
Helpful
2
Replies
CreatePlease to create content