02-09-2006 07:31 AM - edited 03-03-2019 11:42 AM
Can i use AUX port on Route processor (8510) as an input for NTP protocol from GPS device?
Solved! Go to Solution.
02-11-2006 09:54 AM
The code that supports that function fell out of maintenance years ago, and not all IOS devices have it. Very few customers took advantage of it, and maintaining the code to ensure the high accuracy on the serial port was very hard work.
As a result, ongoing support on new platforms was largely discontinued.
If the "ntp refclock" commands exist under the AUX port, it is supported, otherwise it is not.
02-11-2006 09:54 AM
The code that supports that function fell out of maintenance years ago, and not all IOS devices have it. Very few customers took advantage of it, and maintaining the code to ensure the high accuracy on the serial port was very hard work.
As a result, ongoing support on new platforms was largely discontinued.
If the "ntp refclock" commands exist under the AUX port, it is supported, otherwise it is not.
02-11-2006 09:55 AM
And also, only a few devices are supported, those that were existing back when the code was created. I don't know if modern GPS devices speak that same serial protocol these days.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: