Question... the card NM-1T3/E3 supports all the same features that a NM-1A-E3 card does?!
I ask this because a customer has ordered the wrong one, and now we're kind of having problems to get a new one (the correct). Is there any document that I can look to find a way to translate the config to meet the NM-1T3/E3 card needs?!
Actually these are very different cards so that many commands are different. However if the circuit is working, most of the time the defaults will work ok and you just need to configure the IP address.
â¢ ATM Classes of Service support for: Unspecified Bit Rate (UBR), UBR+, Variable Bit Rate real-time (VBR-rt), Variable Bit Rate non-real time (VBR-nrt), Constant Bit Rate (CBR), and Available Bit Rate (ABR)
â¢ ATM UNI 3.0, 4.0 Traffic Management support
â¢ RFC 1483 and RFC 1577 support
â¢ 1024 maximum simultaneous Virtual Connections (VCs)
â¢ 8 bits of VPI (VPI range 0-256), 10 bits of VCI (VCI range 0-1024)
â¢ Permanent Virtual Circuits (PVCs) and Switched Virtual Circuits (SVCs)
â¢ PLCP and HEC cell delineation support
â¢ Operations and Management (F5 OAM) cell support
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.