carrier transitions are bad but all it means is the circuit went down.
If your ATM switch and the router are in the same room it is very unlikely that it is the cable between them. If it really does turn out to be in this connection you have bad hardware most likely.
The more common thing is the atm switch is configured to take the connection down between the router and the switch when it detects another incoming line to the atm switch go down. You will need to look at the logs in the ATM switch to determine if something is going down that would have a affect on the connection to the router.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...