Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATM Configuration

Can ATM be configured without ATM switches between 2 devices having ATM interface?

1 REPLY
Hall of Fame Super Silver

Re: ATM Configuration

Hello Pramod.,

the answer is yes if:

a)one of the two interfaces provide the L1 clock to the other one exact details depend from underlying phyisical SDH or E1:

clock source internal on int atm if SDH based

under controller atm if ATM E1.

B) you use the same VPI/VCI on both sides because no one can change the values

I did this several times in lab setup.

To be noted that you cannot connect back to back two ADSL interfaces you need SHDSL modules see

http://www.cisco.com/en/US/docs/ios/bbdsl/configuration/guide/bba_t1-e1_shdsl_ps6350_TSD_Products_Configuration_Guide_Chapter.html

Hope to help

Giuseppe

121
Views
0
Helpful
1
Replies