Thnks for ur quick reply.I have to make this set up at service provider end so many customers HO will connect to ISP POP of different Bws (2Mbps,1Mbps) through STM ATM Pipe only.I need to seperate there traffic at ISP POP END.HOW TO DO THAT MAPPING.
Different Cust HO ------2Mbps -------ATM CLOUD------STM-1 ----------7206-------DIFFERENT CUST ROUTERS IN POP-------- REMOTE CONNETIVITY USING DIAL UP/VSAT/RF.
I would recommend to look at MPLS L3VPN or Multi-VRF. This will allow to separate the IP routing per customer with support for overlapping IP address space. Each ATM PVC or physical interface can terminate in a customer VRF.
As a starting point have a look at "MPLS Virtual Private Networks (VPNs)" at
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.