Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

ATM configuration

I am trying to configure a Cisco 3845 with a NM-1A-T3 ATM card to pass traffic through to a Marconi TNX-1100. Cells are sent but no data. Does anyone have any suggestions on what is wrong?

Thanks

2 REPLIES
Silver

Re: ATM configuration

In these type of cards mostly hardware failure seems to be an issue.Try replacing the card.Before doing that debug atm bundle errors,debug atm bundle events are the commands used to troubleshoot.Refer the following URL for more info

http://www.cisco.com/en/US/tech/tk39/tk48/technologies_configuration_example09186a0080094e84.shtml

Re: ATM configuration

Hi, can you post the relevant config?

Are there any interface error counters increasing? Could be a payload scrambling issue ... make sure the T3 line settings absolutely match between the Cisco and the Marconi.

Regards, Martin

212
Views
0
Helpful
2
Replies
CreatePlease to create content