Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATM IMA Group T1 ADD

I am not experienced at adding an additional T1 to an existing ima group.

This is the 4th of 4 T1s. The basic interface is already configured.

I believe I need to add the atm1/3 interface to the imagroup? This will make the bandwidth 6M rather than the 4.5M. All of the DLCI/VP/VCI configs are staying the same since this is only an upgrade.

Thanks

1 REPLY
Silver

Re: ATM IMA Group T1 ADD

Easist way is to clone the ATM1/2 configuration onto ATM1/3.

The important part of the config will be:

interface atm1/3

ima-group

You may also have to change your traffic shaping settings under your ATM VC's, if you're using CBR or VBR.

For instance:

interface atm0/ima0.1

pvc 0/32

vbr-nrt 4500 4500

will become:

interface atm0/ima0.1

pvc 0/32

vbr-nrt 6000 6000

Hope this helps

86
Views
0
Helpful
1
Replies
CreatePlease to create content