Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ATM interface impedance command on 3845

i am trying to make IMA bundle with E1 channel. i am using 2VWic-2MFT T1/E1 card on 3845.my old router is 3640 with NM-ATM card. and it has a impedance 120-ohm configured on every ATM interface. now when i tried to configure my new Interface ATM 0/0/0 with impedance 120-ohm, its give me error, there is no impedance command on that interface. how could i setup this command on my atm 0/0/0 interface.

1 REPLY
Hall of Fame Super Gold

Re: ATM interface impedance command on 3845

Hi, for vwic cards the command is "line-termination" under controller E1. The default is 120 Ohm, so you don;t need to configure anything.

Hope this helps, please rate post if it does!

126
Views
0
Helpful
1
Replies