We have a router (Cisco 3660) set up for frame relay in production. About every other day, I have to go in and bounce the ATM interface in order to re-establish connectivity. Unfortunately, I am fairly new to the world of Cisco troubleshooting and I am about half way through the Cisco CCNA cert training. I am not quite sure what I need to look at or exactly how to troubleshoot what may be causing the problem. I have looked in the logs and I have looked at the interface config/status as well as the PVC status. I am not seeing anything questionable, but then again, I am not 100% what to look for. Can anyone with frame experience shed some light on steps I can take to track this problem? Is our ATM interface going bad?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.