Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ATM issue between CE and PE

HI all,

Here is the relevant config between a CE router and a PE router, the service provider says that the circuit is provisioned (sorry I don´t know the exact word, I want to say the ATM circuit is OK).

PE Router (7304):

vc-class atm 4M-IPoA

vbr-nrt 4000 4000 1

inarp 1

broadcast

oam-pvc manage 5

encapsulation aal5snap

interface ATM4/0

no ip address

atm sonet stm-1

no atm enable-ilmi-trap

no clns route-cache

!

interface ATM4/0.10 multipoint

description Conexion con PPAI Oviedo

ip address 10.9.142.1 255.255.252.0

no atm enable-ilmi-trap

pvc 6/76

class-vc 4M-IPoA

oam-pvc manage 5

!

!

CE Router (1721):

interface ATM0

no ip address

no atm ilmi-keepalive

dsl operating-mode auto

!

interface ATM0.1 multipoint

ip address 10.9.142.2 255.255.252.0

pvc 1/40

vbr-nrt 510 510

inarp 1

broadcast

oam-pvc manage 5

encapsulation aal5snap

!

Here is also some output information:

ATM4/0 unassigned YES manual up up

ATM4/0.10 10.9.142.1 YES manual down down

4/0.10 115 6 76 PVC SNAP VBR 4000 4000 1 DOWN

Thanks in advance,

4 REPLIES

Re: ATM issue between CE and PE

One possible problem might be the pvc mismatch between PE & CE:

PE = pvc 6/76

CE = pvc 1/40

Regards,

Leo

New Member

Re: ATM issue between CE and PE

I don´t think so because each device has different VPI/VCI in order to get connectivity with the ATM switched network. They are not directly connected.

Re: ATM issue between CE and PE

In that case you should verify that the ATM switch configuration is correct for these VP/VC pairs.

Leo

New Member

Re: ATM issue between CE and PE

Yes, I agree with you, but the service provider who manage that switch says something like "all is OK here, check your config" and I think the config looks fine... the only thing I can do is contact again but I´m sure about the answer...

205
Views
0
Helpful
4
Replies